×

Attenzione

JUser: :_load: non è stato possibile caricare l'utente con ID: 355590

Main menu

One source is going to be continuous 12 volts, the other will be the ACC (ignition) 12 volts. These two will go together with the red and yellow wires from the harness of the aftermarket head unit. They can be labeled accordingly. Plenty of head units include a connector for this attached to the ground wire. Fasten these in place with some solder and shrink tube. Slip the shrink tube over one of the cables to be joined and transfer it out of the way. Join the wires and dab on a little solder on the wires. Let cool and after that slide the heat shrink tubing within the connection.

You can attempt to look online for the wiring colors, but good luck. They will tell you the "typical" cable colours, but chances are it will likely vary. Two techniques can try to obtain the correct cables. Clip the rest of the wires in the factory harness. You'll be able to test the loudspeakers with a great 9 volt battery to find out which loudspeakers are which. Two cables connected to the exact same loudspeaker will allow it to be pop. Note which loudspeaker makes the pop and attach it from the head unit to that speakers wiring. Make sure that the cables would be the appropriate polarity and I prefer to turn the unit on. An inverse wired loudspeaker WOn't have as good a sound as a correctly wired one. Until each of the speakers are connected continue the technique.

The other way you can follow down the loudspeakers will be to turn on the head unit, but be quite careful to not cross any wires. Begin with some of wires, and attach them one at a time until you get sound. Note which speaker it attach it to that speaker's wires in the wiring harness, taking not of polarity and is. Continue until all the cables are in place. Zip tie the cable together and neatly tuck them behind the head unit. Make sure you've got a great ground wire connection. Make sure that RCAs or signal cables are running away from any electricity wires or Lenkradfernbedienung sources, and aren't run parallel to them.

I've encounter plenty of car stereo systems over the previous 10 years or so. There are so many "techniques" to installing head units. Should you loved this short article and you wish to receive more information concerning Autoradio Adapter generously visit the webpage. Everyone has their very own view of what is right and wrong when wiring up a system, but just as it works doesn't make it right. First, if appropriate, consistently make use of the harnesses. The aftermarket wiring harness will often take the guesswork out of the installation. These harnesses attach to the vehicle's factory wiring harness and provides you with a color coded installation. You simply attach red to red, yellow to yellowish, etc. But is that all an installer should understand?

Car stereos are installed in automobiles to make the driving enjoyable and cozy. For most of the people now a car stereo is a vital element of the car. They can be positioned in the center of the vehicle audio system and therefore are nicely shaped and fitted as to match the insides of the vehicle.

There are car stereos which might be attached to the dashboard and then it'll be a little difficult to get out it. Nevertheless, there are not special tools for the uninstalling process. There are mounts bolted to the automobile. They've been occasionally mounted to the stereo to bring some variation in the process. And one needs to be cautious while removing them. That's the nature of the bolt-on procedure. Website URL:

FacebookG+TwitterRSS